How To Get Rid Of Radon In Home
In every home, safety of the family must always be observed and prioritized. While the house itself and its rooms seem to be the safest places, there are some parts of a home that can pose danger to the family. Places like the attic, basement, and other confined areas can be a source of danger. There you will find loads of things dangerous to you and your family if you do not usually check these places. Among other things, gases seem to be the most dangerous kind of hazard found in these places. You might not know it, but there may be undetectable element that could be living in your basement or attic – and one of the most common elements that attack remote areas is radon.
Radon is a chemical element that can be found in confined areas of almost any building. Because it is radioactive, you may want to get rid of it as soon as possible. But the fact that it is tasteless, odorless, and unseen, makes it very hard for radon to be detected. Radon gas accumulates in remote places in buildings over time because they are not given too much attention. When you discover that radon gas is present in your home, you must get rid of it right away. You can’t risk your family walking in to a room full of radon. It is very radioactive, and very lethal. Here are some steps on how to get rid of radon in home.
Seal the room with radon
You must deal your basement, attic or any other room, including the edges and water drainage systems, where radon is present. A concrete sealant will help close off those gaps and keep the gas within specific areas to isolate its hazardous nature from the rest of your family. A concrete sealant can be purchased from your local hardware store. Be sure that every hole or opening are sealed properly because one little whole is all it needs to get up on surface and toxicate an entire room.
Increase airflow within the house
Radon gases thrive on low air flow, which means a sudden increase can wave goodbye to radon. You have to make sure that the windows and ventilation shafts in your house are open to expel the dangerous chemical. To further benefit from this, consult a professional to expand and increase vents and piping. This is one of the better ways to control where the radon goes without harming anyone.
Use radon barriers
A radon barrier can cover a crawl space’s area. It is a thick plastic that will hold and seal the radon in safe places. In most cases, radon is sealed underground. The radon barrier will then prevent radon from rising up the surface or if in an attic, coming down to the clean rooms. The 10 mil thick plastic will ensure that the radon stays in place so that it will not cause things to go awry.
Plan on putting an exterior radon mitigation system
The radon mitigation system is a unique system that flushes the radon instantly out of your home. This system requires a professional installation to operate since it controls air. One wrong setup and you might have radon circulating within your home instead of drawing it out outside. Recommendation and installation is best left in a professional’s hands.